Page 1 of 1
Help w/ Error Message
Posted: Mon Feb 24, 2020 2:19 am
by BadCorps
I need help with this error message, it occurs when I attempt to cycle through the maps on the Practise Session Setup by pressing the arrows.
Any help would be appreciated, thanks
Re: Help w/ Error Message
Posted: Mon Feb 24, 2020 2:33 am
by Que
https://postimages.org/
Upload your images there perhaps.
Re: Help w/ Error Message
Posted: Mon Feb 24, 2020 2:38 am
by UT Sniper (SJA94)
I guess you are using the old direct3D driver, you will have to update it to a newer one to stop the problem.
Re: Help w/ Error Message
Posted: Tue Feb 25, 2020 12:53 am
by TexasGtar
I've seen that before. Use the Open GL video choice. Oversized textures in a map causing the issue. Figure out which map it is when you are cycling through and see if it has oversized textures in it in the editor. Error message is pretty clear that it couldn't load a texture in the map.
Or just use the Open GL. If you can run that video selection. Be sure to click the show all options because sometimes it won't show you all options.
Open Gl use to be buggier but that was like 15 years ago. Everything will look at lot better too with the opengl rendering.
Re: Help w/ Error Message
Posted: Tue Feb 25, 2020 1:11 am
by Que
Re: Help w/ Error Message
Posted: Tue Feb 25, 2020 8:40 pm
by BadCorps
I fixed it, Open GL didn't work. However I did get a Direct 3D fix and I have no more problems with pushing the button.
Re: Help w/ Error Message
Posted: Wed Feb 26, 2020 12:51 am
by TexasGtar
BadCorps wrote: ↑Tue Feb 25, 2020 8:40 pm
I fixed it, Open GL didn't work. However I did get a Direct 3D fix and I have no more problems with pushing the button.
How did you fix it?
Re: Help w/ Error Message
Posted: Wed Feb 26, 2020 6:49 pm
by BadCorps
TexasGtar wrote: ↑Wed Feb 26, 2020 12:51 am
BadCorps wrote: ↑Tue Feb 25, 2020 8:40 pm
I fixed it, Open GL didn't work. However I did get a Direct 3D fix and I have no more problems with pushing the button.
How did you fix it?
https://www.epicgames.com/unrealtournam ... w-hardware
Under this there was a section for Direct3D fix and I tried it, then it worked.
Re: Help w/ Error Message
Posted: Thu Feb 27, 2020 5:46 am
by papercoffee